Question: Where can I get instructions? Answer: We try to keep our latest instructions updated and available on our support website on our Application Instructions page. These instructions include not only our polyurea products, but our poly-hybrid, epoxy and other … Continue reading →
Question: How thick should it be for a rust proofer? Answer: Anywhere between 15 mils and 60 mils would be suitable depending on whether or not you want to provide full undercoating application for rough service or sound deadening. Many … Continue reading →
Question: I am not sure I understand the tinting process Answer: Basically, all the material is bedliner, but you start by applying a light grey bedliner which includes our powdered products to control texture and vertical build-up. You can get … Continue reading →
Question: Before adding more materials should I clean the gun with Lacquer thinner? Answer: The product can often cure enough to present a problem with clogging unless you are applying as a team where one person is mixing the next … Continue reading →
Question: If the gun gets clogged do I have to take it apart to clean or just spray lacquer thinner through it? Answer: Clogged while just set… yes… spraying lacquer thinner through it will work. Once SL&C is cured you … Continue reading →
Question: The trigger will not slide? What do I do? The gun has not been used. Still new. Answer: That’s because the bushing is new & tight around the sliding rod. Coat sliding rod with some lubricant. Tighten adjuster knob … Continue reading →
Question: I am mixing two cups of A to one cup of B. Is this a good amount to start with? Answer: If your product is a 2:1 ratio, the answer is yes. Less product is best on first mix … Continue reading →